GMOKI-28W - OKIN DeltaDrive Lift Motor for Golden Comforter Wide, MaxiComfort Wide & UltraComfort Montage Lift Chairs

If your Golden wide lift chair won't lift, lifts unevenly, or one side has gone noisy before quitting, this is the genuine GMOKI-28W replacement lift motor.

The GMOKI-28W is the OKIN DeltaDrive GZ wide-chair motor (OKIN part number 1.22.000.403.30) used on Golden's 26" to 33" wide lift chairs. These chairs run two GMOKI-28W motors side by side, kept in sync by a GMOKI-CB control box, so replace the motor that has failed and match it to the one still in the chair. On the MaxiComfort PR505-M26 and PR535-M26, the pair handles lift while a separate GM756R motor handles the backrest.

The motor has a 7-pin black male connector set at a 90-degree angle that plugs into the control box, and it runs on 24 to 29 volts DC. It comes with the push tube shaft and plastic clevis end installed.

Make sure it's the motor. First confirm the chair is plugged into a working outlet and the light on the power supply is on. If you can hear one motor running but the chair won't move, or the chair tilts to one side as it lifts, a motor is the likely cause. If neither motor runs at all, check the hand control and the GMOKI-CB control box before ordering.

To replace it, unplug the chair from the wall and tip it forward onto the footrest or onto its side. Unplug the motor from the control box, then remove the hitch pins and clevis pins at the top and bottom of the motor. Install the new motor in the same position, plug it into the same port on the control box, set the chair upright, and plug it back in.

Not sure which one you have? Call us at 800-798-0325 with your chair's model number and we'll confirm it before you buy.

Golden Technologies: GMOKI-28W
OKIN: 1.22.000.403.30

Manufacturer: OKIN
Series: DeltaDrive GZ
OKIN Part Number: 1.22.000.403.30
Voltage: 24V - 29V DC
Max amps: 2.2A
Max watts: 50W
Duty cycle: 2 min on / 18 min off
Connector: 7-pin black male, 90-degree