MEC2506199 / MEC2506231 - Joystick Mounting Bracket for the Jazzy Carbon 27 & Jazzy Carbon HD Power Chairs

The joystick mounting bracket is the arm that carries the controller on your Pride Jazzy Carbon 27 or Jazzy Carbon HD folding power chair. It fastens to the armrest frame and holds the joystick at a fixed height and angle, keeping the control within easy reach and steady while you drive.

This is a genuine OEM Pride Mobility part — the same bracket your chair was built with, not an aftermarket equivalent. Geometry, mounting points, and factory finish all match the original, so it goes on as a direct fit. Choose the color that matches your chair:

• Black Cherry (Red) — Pride Mobility part number MEC2506199
• Midnight Sky (Blue) — Pride Mobility part number MEC2506231

When to replace the joystick mounting bracket

Brackets take a beating in everyday use. They get caught on doorframes during transfers, absorb the impact when a folded chair tips in a vehicle, and fatigue over time at the bend. Consider replacing yours if the joystick sits at a noticeably different angle than it used to, shifts or rattles when you rest your hand on it, or if the bracket shows a visible bend, crack, or deep gouge. A loose controller is a control problem, not a cosmetic one.

Fitment

Fits the Pride Jazzy Carbon 27 and Jazzy Carbon HD. Color is a matter of matching your chair's trim — both brackets are otherwise identical, so either one physically fits either model. If you're unsure which part number your chair uses, check the label on the existing bracket or the serial plate on the chair frame.

What's included

The bracket ships with the screws that secure the joystick controller to the bracket. No separate mounting screws are needed to attach the bracket itself to the chair.

Installation

Remove the joystick controller from the old bracket, swap the bracket at the chair's existing mounting point, then fasten the controller to the new bracket using the supplied screws. Most owners handle the job with basic hand tools.