CTL2506196 / G0100185 - Joystick with Cable for the Jazzy Carbon 27 & Jazzy Carbon HD Power Chair

This is a complete replacement joystick for the Pride Jazzy Carbon 27 and Jazzy Carbon HD power chairs. The joystick is the control module your hand rests on: it reads your input and tells the chair where to go and how fast. It's the same unit Pride installs at the factory, built for Pride by Innuovo (part G0100185), and it comes with its connecting cable, so you don't need to find a separate harness.

When to replace it: Replace the joystick if the chair drifts or creeps when the lever is centered, if the stick no longer springs back cleanly to neutral, if response is laggy or uneven in one direction, or if the control panel goes dark or shows errors from time to time. A damaged cable can cause the same symptoms, so check for pinching at the armrest pivot, chafing along the frame or a bent connector pin first.

Check your part number: Pride has used more than one controller across the Jazzy range, and the connectors and programming are not interchangeable. The Carbon 27 and Carbon HD use an Innuovo control system rather than the PG Drives or Dynamic controls found on many other Jazzy chairs. Confirm the part number on your existing joystick before ordering.

Installation: The joystick mounts to the armrest bracket and connects to the chair's controller through the supplied cable. Power the chair off completely before disconnecting anything, and route the new cable along the same path as the original so it doesn't catch when the chair folds. If the chair needs programming after the swap, have your dealer or a qualified technician do it.

Pride Mobility part number: CTL2506196
Innuovo part number: G0100185