DWR1020H161 - 100K Ohm Speed Potentiometer (Speed Pot) with Harness for Pride, Go-Go, Mega Motion, & Rascal Scooters

Get full speed control back on your scooter with this 100K ohm speed potentiometer (Pride part number DWR1020H161). It comes with its wiring harness attached, so it connects straight to your scooter's existing plug.

The speed pot is the dial on your tiller console that sets your scooter's top speed. It's often called the rabbit and turtle dial because of the symbols printed around it. When the speed pot wears out, your scooter may run slowly, surge, refuse to change speeds, or not move at all.

This same part is used across many Pride, Go-Go, Mega Motion, and Rascal scooters. Check the list below to make sure your model is included. On some models, fit depends on the console or throttle type or on the serial number, so compare your old part or contact us with your model and serial number if you are not sure.

Pride Mobility Part Number: DWR1020H161

⚠ WARNING California Residents: Proposition 65 Warning

Data coding: 280S0982 2117
Resistance: 100KΩ (100000) Ohm
Base diameter: 18 mm
Shaft unthreaded diameter: 5.60 mm
Overall shaft length (including thread): 15 mm
Thread: M7-1.0
Wiring harness: 3-wire with connector
Harness length: 3-3/4"