Replacement Thumb Throttle for the GOTRAX GXL V2 Electric Scooter
Replacement Thumb Throttle for the GOTRAX GXL V2 Electric Scooter is backordered and will ship as soon as it is back in stock.
Free Shipping
Free Shipping
- US domestic ship to addresses only.
- Does not include expedited shipping services.
Replacement Thumb Throttle for the GOTRAX GXL V2 Electric Scooter
Key Features
- For Slotted Handlebars - Works with slotted handlebars to allow the internal key to slide unto the handlebars. This will not work with standard round handlebars without a slot
- Female End Connector – This throttle includes the female connector end, not the male end. Review images to verify the connector matches your existing connector
- Compatibility - This electric scooter throttle fits GOTRAX Apex, Apex LE, Apex XL, Apex Pro, and GXL V2 along with the Hiboy S2 and S2 Pro, Megawheels S10, and the iScooter i9 electric scooters
- Easy Plug N' Play Installation – The included 7” wiring harness helps to make installation a breeze even if you have no DIY repair experience
- Easy Grip - Features a textured silicone thumb pad and ergonomic design for durability and effortless speed and acceleration adjustments
Description
Description
Do you need a new throttle for your electric scooter? If so, then you have come to the right place for replacement parts and accessories! Take a look at our 3-wire thumb throttle. The thumb throttle, sometimes referred to as a finger speed control or accelerator, is one of the most important pieces of your electric scooter. This throttle is compatible with the GOTRAX GXL V2 electric scooters for adults. Review images to verify the connector matches your existing connector. It comes with a 7" wiring harness with a white 3-pin female connector, making it easy to install. Please note, this throttle comes with an internal key, or nub, that will slide into slot on slotted handlebars.
INSTRUCTIONS
-Disconnect battery
-Remove grip
-Loosen set screw on bottom of throttle
-Disconnect throttle harness from the main harness (access may differ between models)
-Slide throttle down about an inch and remove rubber insert from handlebar slot
-Gently pull harness through and slide throttle off handlebar
-To install, repeat instructions in reverse being careful to align parts in the slot on the handlebar
⚠ WARNING California Residents: Proposition 65 Warning
Reviews (0)
Reviews (0)
Specifications
Specifications
Wire length: 6-1/2"